The Powder Toy

fan won't work

  • jrd1121     27th Mar 2013 Member 0 Permalink

    i did what the instructions said bt fan wont make air pressure. also air is set as on

  • greymatter     27th Mar 2013 Member 0 Permalink

    If the fan is too small and if you ended the line too close then the fan will generate a very small amount of air velocity and pressure. Try placing a large block of fan and drag the line tool all the way to the other end of the screen.

  • jacob1     27th Mar 2013 Developer 1 Permalink
    I used to not be able to understand FAN either, but I eventually figured out I had to start the line tool on top of the FAN.

    Line tool is holding shift by the way.
  • bimmo_devices     28th Mar 2013 Member 0 Permalink

    I think fan being too close to the boundary deletes the pressure as it is created - I tried to make a simple wind tunnel.

You need to login before you can post replies