The Powder Toy

Videogamer555

This is a simple plasma cutting torch that can cut through thin pieces of metal in TPT, while making a hole not much wider than the plasma stream itself. The semiconductor diode is used to keep the charged plasma from accidentally sending a signal back up the wire as it sometimes tries to do.

411467View Save 411467

Edited by Videogamer555, 2011-06-29 07:43:40

plead-for-destruction

@Videogamer555 (View Post)
not very good, but its your first step into the world of lasers and flamethrowers

darkhunter

u can put some white hole or air vent into it. It will shoot faster! I vote up so from -2 > -1.

boxmein

It's a nice beginning. Please now discover GoL and the ways you could use heating the elements. Then use ETRD to create blasts of hot plasma(NBLE doesn't make quite hot plasma). Make something electronic or artistic. Then you'll rank up.

Videogamer555

I upgraded it now and uploaded it as Plasma Cutter 2. Now it uses a small amount of VENT to slightly increase the pressure in the back of the plasma torch.

412764View Save 412764

Edited by Videogamer555, 2011-06-30 06:05:32

JH-Darkfire

Use the THDR-VOID effect, it makes instant pressure.

Videogamer555

And here's another upgrade, but I had to sacrifice total storage volume of the NBLE by adding lots of VENT for even more pressure.

412768View Save 412768

@JH-Darkfire (View Post)
Thanks for the advice. I've just upgraded according to your specs. I think it works even better now.

412773View Save 412773

Edited by Videogamer555, 2011-06-30 06:20:11

code1949

@Videogamer555 (View Post)
Here's what I did to it:

412770View Save 412770

JH-Darkfire:

Use the THDR-VOID effect, it makes instant pressure.

Yes but PCLN-THDR is even better!

Edited by code1949, 2011-06-30 06:22:23

JH-Darkfire

@code1949 (View Post)
Oh yeah.

Videogamer555

Here's what's likely my last upgrade to it, and it's only a bugfix from the previous version I made. In my previous version, the exit velocity was so great after running it continuously that many NBLE atoms skiped the ionization grid altogether and left the gun as NBLE, instead of PLSM, and you'd have to let off using the SPRK quite frequently. I fixed that this time by making the ionization grid larger. Though a lot still leaves as NBLE, this time it's mostly PLSM even after running the device (holding SPRK on the power cable) for a long time.

412792View Save 412792