Tool to help configure elements

  • BrianTheEngineer
    30th November Member 0 Permalink

    My feedback is that you implement a tool to help us configure DRAY, CRAY, and FILT. I got this idea from a TPT mod called The Subframe Chipmaker Mod. It helps us config the properties of DRAY and CRAY in an easy way. However I like to use Jacob1's Mod, so the only way I could use the tool is to stamp my creation, then transfer it to the stamp folder of the Subframe Mod then config it there, transfer it back. This seems to be a huge waste of time for a trivial task.

    Edited once by BrianTheEngineer. Last: 30th November
  • moonheart08
    30th November Member 0 Permalink

    This will likely be done. Problem is it takes time to make a good UI.

  • BrianTheEngineer
    1st December Member 0 Permalink

    @moonheart08 (View Post)

     

    Then, is there a way to move the code for the tool over to Jacob1's Mod

  • Cracker1000
    1st December Member 0 Permalink
    @BrianTheEngineer (View Post)
    Unfortunately, the tool is coded in C++ not lua so moving it isn't that easy but it is not impossible to move it, infact i was thinking of including the config. and stack tools in version 11 of my mod though.
    Edited once by Cracker1000. Last: 1st December