Well,duh-just a few element suggestions
-
SURF-surfactant
Is a liquid.
could attach itself on powders, solids, and a few liquids such as GEL and PSTE, but can't attach to each other and only attach on only one side at a time.
If it is attached at a powder, it partly shares the velocity with it, and it is hard to move in the direction opposite to the direction where it is attached(example:if a SAND particle is attached at side 4(down-right),it can't move up-left.The attach direction is saved as tmp.).If it's attached at a solid, it's velocity will slowly become 0, and it will be hard to accelerate it. The attach direction could randomly shift,and even if the element at the attach direction changes, it will continue to attach at the new element.
Freezes into ICE and liquid SOAP when under low temp and evaporates into WTRV and liquid SOAP when under high temp.
Can be made with RIME+SOAP.
SOLV-solvent
Is a liquid.
Made from mixing SURF and WAX (why I do not know but it looked nice).
When spawned, has a ctype of SOLV. Can dissolve other elements and turn its ctype.
When its ctype is BRMT, and is near METL, turns into METL and spawns another particle of SOLV.
When its ctype is SALT, and is near METL, turns into SALT and dissolves the METL, spawns SOLV(BRMT).
When its ctype is BREL, and is near electronic parts(the one which brokes by EMP), turns into one of those those electronic parts and spawns SOLV.
When its ctype is PQRT, and is near QRTZ, turns into QRTZ and spawns SOLV.
Etc,etc(there are too many...)
turns into SOLG(solvent gas) and its ctype(except it is SOLV) when in high temp and turns into ICE and SOAP and its ctype (except if it is SOLV) in low temp.
Changes place with nearby liquids.
Edited 2 times by crazylab. Last: 23rd Jan 2022 -
These elements don't seem useful and SURF's effect on powders seems akin to moving solids.
-
I was just a bit annoyed by some GEL violently moving when attached to a pixel.
Aaaand I don't know why but I thought about waterproof-coating.
SURF attach to only one particle at a time to avoid the moving solid problem, I do not want it to be GLUE or something like that. Maybe SURF could be lighter than usual powders or liquids?
SOLV can be used to remove and reconstruct damaged electronics.
-
SURF:
GEL can attach to most things, but its strength on liquids is limited. SURF would be useful here.
The powder thing seems like moving solids, like @MachineMan said.
I would suggest maybe changing the creation a bit, also if it freezes and evaporates into ICE and SOAP, it's very hard to recover the original liquid.
SOLV:
I really don't know, this is so complicated.
