smoke alarm

  • joe-mama
    8th October Member 1 Permalink

    i just want opinions whether my smoke alarm is good or not.

    Edited 3 times by joe-mama. Last: 10th October
  • joe-mama
    10th October Member 1 Permalink

    No opinions??

  • Artemv80
    14th October Member 1 Permalink
    It is in working order, but sometimes the sensor itself (the smoke detector that opens the water valves) burns out when exposed to fire.
  • joe-mama
    14th October Member 1 Permalink

    @Artemv80 (View Post)

    yeah i noticed that. should i make it another material?

  • Artemv80
    14th October Member 1 Permalink

    @joe-mama (View Post)

    Probably, yes. I would make the shell thicker (using two pixels of TTAN) and remove all the burning elements.

  • joe-mama
    14th October Member 1 Permalink

    shell? but doesnt TTAN conduct electricity? that will mostly be a problem

    Edited 2 times by joe-mama. Last: 14th October
  • Artemv80
    14th October Member 1 Permalink

    @joe-mama (View Post)

    Sorry if I wrote anything incorrectly; I'm Russian guy and used a translator.

    TTAN does conduct heat, but it protects against instantaneous burning. If you are looking for complete protection against burning, you need to find a material that does not transmit heat at all.

     

    Edited 2 times by Artemv80. Last: 14th October
  • joe-mama
    14th October Member 1 Permalink

    @Artemv80 (View Post)

     you didnt write anything incorrectly. you think using BRCK would work?

  • Artemv80
    14th October Member 1 Permalink

    @joe-mama (View Post)

    Probably only if you make a 2-pixel-thick shell out of it (3 by 6 pixels).

     

    Edited once by Artemv80. Last: 14th October
  • joe-mama
    14th October Member 1 Permalink

    @Artemv80 (View Post)

     ok. i will try that and then CRMC and see which one is better CRMC is better at not conducting heat a lot, nor electricity.

    Edited 2 times by joe-mama. Last: 14th October