dornog70

41 / 3

22nd Feb 2025

26th March

A coal fueled power plant that is capable of producing 300-400C steam. (check out my other creations :>)

power coal coalpowerplant bomb plant realistic fire steam water explosive

Comments

dornog70 29th March

The exact cause of the mill fire is because of the potential of burning coal to fly out from the bottom of the furnace, if you dont want this random event you can add another layer of titanium to the bottom of fire box
dornog70 26th March

Oil is limited so try not to use it for a long time
dornog70 26th March

Oil burners should be used when the flame is dieing out and needs an extra temporary boost, during initial ignition, and for facilitating even fuel burn
dornog70 26th March

TO START: Reset MFT and fill the furnace to about ~10% with oil using the oil burners > Start fans, wait for oxygen to reach the mills then start mills, immediately ignite the oil with fire AND enable the coal burners. Oil burners should be turned off after the fire sustains itself after a couple of seconds
dornog70 26th March

and, here is a few tips and how to start up if you do not know:
dornog70 26th March

1. Stop the mill and the fans 2. Trip the furnace and all burners if not already 3. discharge CO2 into the mill to completely suppress the fire (i will be adding some sort of automatic CO2 based fire suppression and making the mills steam-inerted later)
dornog70 26th March

The mills will catch fire if there is a break: so here is a short procedure on mitigating a mill fire
pickle4L17 26th March

Something caught on fire and then the mills exploded
Reshiram 26th March

Woah! This looks amazing!
pickle4L17 25th March

YOOOO I NEED TO SEE THIS

The Powder Toy