The Powder Toy

Molten Salt Reactor by Oyne31

Oyne31
Oyne31
17 / 0
29th November
5th December
Use 'Anti-Lag button' if not getting 60fps- speeds up simulation. Any suggestions appreciated

Comments

  • Spyknt
    Spyknt     5th December
    nice! thanks for keeping it updated
  • Oyne31
    Oyne31     5th December
    TheDanster, Spyknt: Thank you for the tip- I'm sorry it took a bit but now everything should work as intended
  • Spyknt
    Spyknt     5th December
    the heat transfer system still does not work, tsns doesnt actually transmit to anything...
  • Spyknt
    Spyknt     5th December
    much better now! very well made save +1
  • TheDanster
    TheDanster     5th December
    Love this save! Just a few notes about the heat exchanger and the coolant towers. The TSNS is triggered by the wifi channels next to it, so it's always active even if the CRMC around it is a lower temperature. Also it seems like the logic for the heat exchanger is backwards? When the nearby temp is over 1500C, the system raises the HEAC, cutting the tie between the molten salt loop and the coolant towers. Other than that the reactor is pretty cool!
  • Oyne31
    Oyne31     5th December
    Watermelon0254- Thank you :D (Updated to stop wifi channel clashing)
  • Powderexe
    Powderexe     4th December
    You have an amazing talent!
  • Watermelon0254
    Watermelon0254     4th December
    Nice! +1
  • Oyne31
    Oyne31     3rd December
    12/3/2024 Changed Secondary loops- might add a way to get core to heat faster.
  • Oyne31
    Oyne31     3rd December
    Sorry I havent been around much- the little panel has control rods in red and green as well as a heating and cooling system; the heat exchangers operate when the salt above 1500C but I am intending to update this soon.