kit237
kit237
36 / 3
28th March
31st March
i speedruned it 48 hours after the official release of the element! hopefully it will end up on the wiki page about rsst as an example of use :P blue and red signs can send you to a save/thread on the forum when clicked
rsst printer 3dprinter 2dprinter first wiki resist resistcup

Comments

  • Nehkorn
    Nehkorn
    28th March
    i forcefed the printer electrons and it crapped out a bit of rock with tungsten and a hole so thats very good
  • kit237
    kit237
    28th March
    bodester: i didnt really understand the essence of the question, perhaps you forgot to unpause or past the photon disk in the wrong place
  • bodester
    bodester
    28th March
    how make it go
  • EnganK
    EnganK
    28th March
    Nooooooooo
  • kit237
    kit237
    28th March
    the save was created at 7:20:30 PM, your comment was sent at 07:29 PM (i entered through ultimata), you are disqualified
  • EnganK
    EnganK
    28th March
    I speedruned like and comment 5 minutes after the official release of this save! +1