The Powder Toy

RBMK-1000. Reactor No. 4 by MaxD

MaxD
MaxD
117 / 6
4th Oct 2020
27th Jan 2021
Please do not copy, it only results to downvotes. instructions: water: SPRK the top button to add water, middle button for water flow, and bottom button to remove water. control rods: buttons on bottom; insert. buttons on top; remove inspir. ID 2001108
ussr mikhail c0mmunism chernobyl liquidator explosion meltdown ukraine

Comments

  • MaxD
    MaxD     6th Oct 2020
    ChEekI BrEeKI iV dAnKE
  • MaxD
    MaxD     6th Oct 2020
    a nuuuu...
  • LeGasp
    LeGasp     6th Oct 2020
    -russian music intensifie-
  • MaxD
    MaxD     6th Oct 2020
    whoever wanted to see it explode, id:2592324
  • MaxD
    MaxD     6th Oct 2020
    IlikeUssr, XD thanks
  • CCl2F2
    CCl2F2     6th Oct 2020
    hey, +1 for our symbol
  • docRoboRobert
    docRoboRobert     6th Oct 2020
    As it was said, PTCT is water spheres cools water too much. Reduce the amount significantly or remove it from there and place somewhere else.
  • docRoboRobert
    docRoboRobert     6th Oct 2020
    I reccomend insulating insulating the system. Most of heat is lost to the envirorment. 2ndproblem is how piping works. When you insulate reactor and finally reach the temperature to make steam, water in pipes will turn into steam and the steam will almost completely block the access to the core.
  • MaxD
    MaxD     6th Oct 2020
    DarkGabriel, it's not hard, just never insert the control rods ;)
  • MaxD
    MaxD     6th Oct 2020
    EpsilonStudios, I have alslo noticed that. The problem is, is that first of all, it will eventually produce hot enough steam, but when it does succesfully pass through the turbine, it's hard to cool it back down to go back through the actual reactor.