The Powder Toy

B29K1QS60 by unnick

unnick
unnick
60 / 2
21st Jun 2019
22nd Jun 2019
yay im alive! anyways i made a computer, which is very similar to arK's advanced programmer in his AEC 2 save. instructions on how to use it and the thread are in the save.
subframe computer

Comments

  • unnick
    unnick     21st Jun 2019
    LBPHacker: okay, i followed your suggestions and i also added information about the order things happen in the cpu when it encounters an ambiguous instruction (like when an instruction sets some bits and conditionally jumps depending on those bits) to the thread
  • LBPHacker
    LBPHacker     21st Jun 2019
    As a side note, this is relatively tricky to use if you don't know what you're doing exactly and what to expect. I suggest maybe pre-loading the addition demo and explaining how to use the keypad?
  • LBPHacker
    LBPHacker     21st Jun 2019
    Well, since I have an assembler practically ready for my next computer (which is, unlike the assembler, is still in the "trying to figure out what the hell I'm doing" phase), I could wire it up to assemble stuff for this CPU too. I was planning to have it support multiple backends anyway.
  • Unicellular
    Unicellular     21st Jun 2019
    unnick: programming is always pain, if you barely understand how it works (as I do), but it is impressive, that you can create some kind of powerful computer here.
  • unnick
    unnick     21st Jun 2019
    Unicellular: probably if you connect a suitable screen to it, but programming for this computer is a pain.
  • Unicellular
    Unicellular     21st Jun 2019
    But can it run tetris?
  • Maticzpl
    Maticzpl     21st Jun 2019
    But can it run half life 3?