The Powder Toy

B29K1QS60 by unnick

unnick
unnick
60 / 2
21st Jun 2019
22nd Jun 2019
yay im alive! anyways i made a computer, which is very similar to arK's advanced programmer in his AEC 2 save. instructions on how to use it and the thread are in the save.
subframe computer

Comments

  • kofeeeychi
    kofeeeychi     13th Jan 2022
    hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi hi (him was print this)
  • yclee126
    yclee126     25th Jun 2019
    Nice use of LDTC there
  • Garuda
    Garuda     24th Jun 2019
    +1 (Too short)
  • Garuda
    Garuda     24th Jun 2019
    I like saves that i can modify myself.
  • dronepunch
    dronepunch     24th Jun 2019
    very good!
  • TheCARNUFEX
    TheCARNUFEX     22nd Jun 2019
    Utterly good save i must say +1
  • unnick
    unnick     22nd Jun 2019
    okay. (comment too short)
  • LBPHacker
    LBPHacker     22nd Jun 2019
    Cool. I'm working on the assembler now, will ping you later here. Or you could hop into #powder-subframe.
  • unnick
    unnick     22nd Jun 2019
    LBPHacker: alright i inserted that into the save too
  • LBPHacker
    LBPHacker     22nd Jun 2019
    Nice! Could you insert id:2435912 into your save in the meantime? That'll help the assembler figure out where to write the code. Just put it wherever, I'll check back in a few hours to see where it is relative to the program ROM.