The Powder Toy

Paladin class Warship by PlazmaticCoffee

PlazmaticCoffee
PlazmaticCoffee
4 / 0
8th May 2018
9th May 2018
Tridents largest warship the Paladin is always on the site of Planetery Invasions and normaly commands fleets into battle, please leave a comment to tell me what you think of this creation.
space ship battleship

Comments

  • PlazmaticCoffee
    PlazmaticCoffee     9th May 2018
    yay thanks for the help
  • Technomancer
    Technomancer     9th May 2018
    That's much sturdier. I tries the particle beams again and the midsection held up almost as well as the stern this time.
  • PlazmaticCoffee
    PlazmaticCoffee     9th May 2018
    UPDATE: Hanger area has been ripped out and remade on a lower section, still the same dropship amount in there but just lower not to make room for more armor, and interior at a highlighted weekspot pointed out by Technomancer.
  • PlazmaticCoffee
    PlazmaticCoffee     9th May 2018
    hu intresting i see your point, where normaly it would have a outer armor plate around the hanger sides, it would still be a weekenss for the ships superstructure. IT CALLS FOR A MAJOR RE-DESIGN OF THE SHIP (grabs hammer and runs) (expect update soon)
  • Technomancer
    Technomancer     8th May 2018
    Observe - id:2281319 (yes, I built a weapon specifically to prove my point!)
  • Technomancer
    Technomancer     8th May 2018
    Good to see you're still making these. This one has a pretty major design flaw though. That thin section above the hangar, bridging the bow and stern, is not only weak structurally, but obviously so to any enemy. Consider either adding some sort of shield system, at least to that section, or thickening it upwards (either move the protruding section above it higher, or just fill the spce between the two)