4 Bytes of PROGRAMMABLE ram! + lcd by JF58

JF58

2 / 2

1st Dec 2017

1st Dec 2017

Finnaly in use. Kind of complicated and not space efficent but good nonetheless. To code a number: first lcd = first 7 aray on the bottom the ones pointing up. 1st aray is the top lcd, 2nd is the left most on the upper half and the 3rd is the right most.

Comments

• 

  Terortemper 18th Mar 2023
  TehBoxtrot94: kid
• 

  TehBoxtrot94 27th Mar 2018
  no u -1
• 

  JF58 1st Dec 2017
  sorry for the instructions being so long :( and sorry for being so confusing, ill make improvments soon
• 

  JF58 1st Dec 2017
  and last is, near the read switch is a tiny button (only 2 pixles) is the clear lcd
• 

  JF58 1st Dec 2017
  the long thin line protruding from the place where you clear mem is the read switch this will display to lcd
• 

  JF58 1st Dec 2017
  the big rectangle on both bottom and top is clear memory.
• 

  JF58 1st Dec 2017
  to trigger do the display and clear mem/ clear lcd is as follows
• 

  JF58 1st Dec 2017
  then the ones after the insl on the top are for the 4th lcd, again same config
• 

  JF58 1st Dec 2017
  It gets complicated here because the last 2 on the bottom are the first for the 3rd lcd, theres 2 on the bottom and 5 on the top near the lcd. same config for these
• 

  JF58 1st Dec 2017
  The second set of 7 is between the insl, these are the same and control the 2nd lcd.