Something on Layering by FuriousWeasel

FuriousWeasel

7 / 0

26th May 2017

9th Jul 2017

Particles can stack themselves by creating something like PROT over a particle, then converting that into something you want. Or after converting it, you can use DRAY to replace it with something else. edit: published

electronics

Comments

• 

  FuriousWeasel 9th Jul 2017
  @NoVIcE: indeed. You can also potentially dray it to somewhere else to store the ctype, delete the original filt. Then dray/stack it onto a secondary location to preserve its #.
• 

  FuriousWeasel 9th Jul 2017
  Something cheeky that filt does in reguards to layering is that the filt with the LOWEST # in the stack is the only one that get interacted with.
• 

  NoVIcE 9th Jul 2017
  You could however, stack filt and move with pistons different layers, thus switching between different filt-s.
• 

  FuriousWeasel 9th Jul 2017
  nvm about 3D ram, that's impossible. Layers can be sequentially accessed though. Which could still enable large amounts of data to be stored at the cost of time to access the layers.
• 

  FuriousWeasel 26th May 2017
  I experimented with this a short while back and was going to create a prototype for 3D FRAM. But so far, I could only think of designs that would be impractically large & grow linearly.