agustrusher
agustrusher
1490 / 38
14th Dec 2014
31st Mar 2018
Witness the life and death of a P.T. star with this little fusion chamber. Stars will slightly differ every replay. Last 2-4 min. This was so fun to make. Enjoy! Credit goes to Alfa(id:1683916) and Alexzander(id:1689167) for inpiration of chamber design.
fusion cycle star heat life chamber realistic nuclear power reactor

Comments

  • Sydneymotor2
    Sydneymotor2
    17th May
    @AsteroidBennu Great finding, despite this save being over 7 years old it keeps surprising me how this has so many reactions
  • Thecreative8
    Thecreative8
    13th May
    did mine turn into a neutron star? (near the end suddendly released a lot of oxygen and then started spewing out a LOT of neutrons)
  • AsteroidBennu
    AsteroidBennu
    3rd May
    or it can just burn CO2 when it is hot enough (8000C+)
  • AsteroidBennu
    AsteroidBennu
    3rd May
    found that when you mix NBLE and CO2 in ratio between 1:1 or 1:3 it makes the star use the CO2 as a fuel and turns it into OXY
  • Anthony_Sti
    Anthony_Sti
    28th April
    I also added ISOZ and made the setup in the middle even more compact and it just exploded into a dense OXYG clump
  • Anthony_Sti
    Anthony_Sti
    28th April
    I made it go supernova and turn into an OXYG dwarf by changing the setup a bit
  • Mike_hawk
    Mike_hawk
    25th April
    mine quite literally dodged death because I tried to kill it with dmg and dest which sent it into phase five and four at the same time for 15 minutes until it died and I put dust and water to replace it and it's so far going good
  • CATSSMAC
    CATSSMAC
    20th April
    this comment is 34 characters long
  • Commenter123
    Commenter123
    16th April
    mine went supernova almost immediately, then it came back and skipped to phase 2, became a neutron star and filled eith co2 then went supernova again and died
  • EagleFun2
    EagleFun2
    10th April
    if you put in some ISOZ it gets funky