The Powder Toy

Continous Scroller (almost) by nijalninja98

nijalninja98
nijalninja98
4 / 0
1st Oct 2013
3rd Oct 2013
it scroll's without the long breaks of most, but it is not 100% continous. for this design this the best i could do, and for it's size it is not that bad.

Comments

  • nijalninja98
    nijalninja98     3rd Oct 2013
    ok there should be no more bugs, the AEC club logo works. and thanks to thiskal it is closer to a continous scroller.
  • nijalninja98
    nijalninja98     3rd Oct 2013
    yep i will do both thnx thiskal. sorry china-richway.
  • china-richway2
    china-richway2     3rd Oct 2013
    recopy my logo pls, it's ugly
  • thiskal
    thiskal     2nd Oct 2013
    nicely made and so close,its very easy to fix just place the upper aray laser 2 pixels up and the lower 0ne 2 pixels down so the piston extensions and the aray lser are on the same line and the bray cant get stuck behind in
  • nijalninja98
    nijalninja98     2nd Oct 2013
    HAHA i have fixed it and it is now batter than before. and it does not bug on the third time, hooray.
  • nijalninja98
    nijalninja98     2nd Oct 2013
    thanx for liking it i have to fix it but i have been spending time on other stuff but u might fix it now. and i know about the logo.
  • aeclubpowder
    aeclubpowder     1st Oct 2013
    PLEASE turn off all simulation modes. My logo seems ugly...
  • the-scarecrow
    the-scarecrow     1st Oct 2013
    it screws up on the 3rd time
  • FALCON
    FALCON     1st Oct 2013
    it stuffs up but it is still better than i could do so +1 and it is a good save i can tell alot of effort went into this save because i can do some electronics but not like this so overall great job!
  • nijalninja98
    nijalninja98     1st Oct 2013
    do ont judge this save just recently i have found large bug that i cant seem to iron out so look at it but dont judge it pls.