The Powder Toy

Pressure sensor with electrical output by gaysanta

gaysanta
gaysanta
2 / 1
25th Feb 2013
28th Jun 2014
please leave a comment.

Comments

  • gaysanta
    gaysanta     26th Feb 2013
    ok thanks again :-) +1
  • Amphealy
    Amphealy     25th Feb 2013
    No problem. I will add, That the DSTW mechanism I mentioned will not work with Ambient Heat Simulation option as it causes the DSTW temperatures to average out. There might be a way to work around this but I could never figure it out.
  • gaysanta
    gaysanta     25th Feb 2013
    And btw your saves are awsome#!
  • gaysanta
    gaysanta     25th Feb 2013
    Thank you very much for commenting. +1 on all you saves oh and thanks again
  • Amphealy
    Amphealy     25th Feb 2013
    Why not just use boiling point of DSTW under pressure. DSTW acts somewhat like real water in that pressure will change the point at which it will turn to WTRV(steam). With DTEC you can monitor the transition to give electrical feedback. With calibration it can be used to detect specific pressure values with a reasonable degree of accuracy. If you're interested I have a save called pressure detector, which provides a simple demonstration of the use of DSTW as a pressure detection mechanism.