Difference between revisions of "Element:DTEC"
m (Added more links) |
bwbellairs (talk | contribs) m (Added PHOT as DTEC also transfers it's CTYPE to a neighbouring FILT) |
||
| Line 42: | Line 42: | ||
You can set the tmp2 to determine the detection radius (in the shape of a square) | You can set the tmp2 to determine the detection radius (in the shape of a square) | ||
| − | DTEC can also detect the | + | DTEC can also detect the ctypes of a {{material|BRAY}} and {{material|PHOT}} in its tmp2 range and transfer it to a neighboring {{material|FILT}}. This is useful for FILT ctype based electronics. |
{{Languages}} | {{Languages}} | ||
Revision as of 21:34, 28 November 2017
| Properties | |
|---|---|
| Section | Sensors |
| Spawn temperature | 22°C |
| Heat Conductivity | 0% |
| Relative weight | 100 |
| Gravity | 0 |
| Acid dissolve rate | 0.1% |
| Flammability | 0 |
| State | Solid |
| Source code | |
Detector generates a SPRK when its ctype element is nearby. To set its ctype, draw over it with an element like you would with CLNE. Make sure you don't accidentally set its ctype when drawing the wires around it. DTEC is a replacement for detector wall so that you can make your creations smaller.
You can set the tmp2 to determine the detection radius (in the shape of a square)
DTEC can also detect the ctypes of a BRAY and PHOT in its tmp2 range and transfer it to a neighboring FILT. This is useful for FILT ctype based electronics.
| Language: | [[::Element:DTEC|English]] |
|---|
