The Powder Toy

The-Fall

Name: Fission Control element.
Uses and properties: Used to limit neutons in a fission reaction. Such as control rods in a reactor. Will only absorb heat from neutrons. If the control element reaches pressure above 100, it will stop neutrons from passing through it by absorbing them and will bring pressure down to 0, if below that limit, neutrons may freely pass through it. It will limit the number of neutrons that pass through it if that number is greater than 30 neutrons per frame. If the fission control element reaches heat levels over 500 C, it will absorb neutrons from passing through and will block heat and pressure, If below 500 C it will allow neutrons to pass through and pressure to pass through. Can be activated or deactivated via eletricity.

tommig

sound very hard to code but, +1

Cr15py

So wait... it will absorb neutrons if pressure is above 100, and then generate negative pressure until pressure reaches like 10 or something? And it will be come with an on/off switch and will constantly limit neutron movement? I guess +1.

therocketeer

@The-Fall
why not just call it lead, lead blocks/absorbs radiaton. But it doen't do the temp thing.

EDIT: wait, we need something that absorbs neutrons instead of reflecting them. Am i not correct?

The-Fall

@therocketeer
It absorbs them once its pressure heat or number of neutrons becomes too high.

Xenocide

I have LEAD and LLED

The-Fall

@antb
Yes, but It melts and isnt in the official.
Lead is viable yet doesnt do everything I need this element to do.

Neutron moderating element.