Heat Protection

  • Gloopy
    20th Apr 2011 Member 0 Permalink
    I have a current ongoing project that requires large amounts of heat but the "wires" if you will that control the device and consist of PSCN and WIFI, keep melting. WALL is too big to fit in the small area, so I need suggestions of other particles that are heat resistant and will properly protect the wires. I have used INSL but it just melts and causes a bigger problem. Can you help?

    Thanks

    -Gloopy
  • Neospector
    20th Apr 2011 Member 0 Permalink
    How large is the area in question? It might be possible to construct a FILT system that receives it's low temperature from farther off.
  • Gloopy
    20th Apr 2011 Member 0 Permalink


    Here is the specific area. ( I can't give away the entire project ) But here you will see the INSL that i am currently using. DO NOT UNPAUSE
  • Neospector
    20th Apr 2011 Member 0 Permalink
    Erase the pixel that touches the heat switch.
  • Gloopy
    20th Apr 2011 Member 0 Permalink


    Problem Solved! I also Removed the INSL and sunk the wires further back into wall to protect them.
  • BreakingNYC
    20th Apr 2011 Member 0 Permalink