28 / 5

28th September

15th October

this design is more reliable and faster than my older one, but it takes up a bit more space. still, is good.

sans protein kris friend arts deltarune renewable factory clst infinifactory

Comments

gabriel_ultrakill 2nd October

that would have some issues. the way i'm removing the excess quartz growth is with double-sided E-wall, and removing 1 side would significantly hamper its removing ability, forcing a longer cycle to ensure the system won't get jammed up. also, that would result in some -1 tmp quartz, while my method ensures entirely pure quartz. using cray for regenerating the catalyst is like using cray(bray) for heating/cooling.
netherpro 2nd October

So you don't have to bother about using cray in a factory
netherpro 2nd October

And it would be rather simple as you just need to use a pstn to pull and push the layer above the frme to swap the role
netherpro 2nd October

The best approach is setting the previous catalyst to be product and the new product as catalyst so the chain never ends
gabriel_ultrakill 2nd October

also, the stuff that's pulled out is not the stuff that's regenerated.
gabriel_ultrakill 2nd October

the quartz catalyst stops working after some time. replacing a catalyst is fine.
the_fan_of_tpt 2nd October

sans*(cts is so dumb omg)
the_fan_of_tpt 2nd October

as a undertale MASTER (i beat every route) nice pun sand
Tadpole1 2nd October

I mean like to dump sltw you can always use PVOD.Then the ewall part can be used to put qrtz catalyst that can always remain without being pulled out.
SiIent 2nd October

lolol this feels familiar

The Powder Toy