Migulel

21 / 1

20th August

30th August

To start up: open the CST 1 valve or CST 2 valve or both to allow condenser to get water withdraw rods and monitor the temp its good to keep fuel rod temp at around 700 at startup open turbine preheat valve to preheat turbine rest of instructions are in

bwr4 nuclear mark2 light turbine reactor water boiling mark powerplant

Comments

KyleTheCreator 22nd August

Migulel: its genuinely way bigger than anything I can do
Migulel 22nd August

KyleTheCreator: huh?
KyleTheCreator 22nd August

Genuinely how the (HYPERLINK BLOCKED) can (YOU) DO THIS?!?!?!?
KyleTheCreator 22nd August

I genuinely want to swear, but Thereactorguy2054v2 will be a pain and ban me again, so.
Migulel 22nd August

Also if you have any kind of ideas how to make it better or more realistic tell me
Migulel 22nd August

Oyne31: Thanks that fixed it but i have no idea even what caused it and why was it only in the most left control rod and not all. weird
Oyne31 22nd August

I believe you could probably fix the pstn issue by setting their ctype to pscn/wifi- ctype of pstn determines what it will be stopped by. (+1'd earlier)
Migulel 21st August

also If you dislike please tell why
Migulel 21st August

ArandomTPTGuy: I am also aware of that and i do not know any fix except if it happens just lower rods all the way down and its fixed for a bit
ArandomTPTGuy 21st August

for some reason the leftmost rod after a long time fails and gets the PSCN pushed by PSTN and goes off orientation from other rods when raised

The Powder Toy

Mark II BWR/4 by Migulel

Comments