Migulel

22 / 1

20th August

30th August

To start up: open the CST 1 valve or CST 2 valve or both to allow condenser to get water withdraw rods and monitor the temp its good to keep fuel rod temp at around 700 at startup open turbine preheat valve to preheat turbine rest of instructions are in

bwr4 nuclear mark2 light turbine reactor water boiling mark powerplant

Comments

Migulel 28th August

added automatic scram system that scrams when reactor is over 1200C
Migulel 28th August

chromeuser: did you use polonium
chromeuser 27th August

This is a very nice reactor I took it and modified some things and it was very easy to make it use real nuclear fuel that uses actual neutrons unlike 99% of all tpt reactors using uranium, I also successfully made refueling possible and it works well and does it right
dornog70 26th August

this is incredible
AlexGuy120 25th August

You need to see this. https://powdertoy.co.uk/Discussions/Thread/View.html?Thread=28042
KyleTheCreator 25th August

Goobism
Migulel 25th August

i'd like some feedback because the comment section feels a bit like a ghost town
Migulel 25th August

layout*
Migulel 25th August

KyleTheCreator: also the second reason why it does not have 4 fuel rods and 3 control rods is because when i was still making this reactor last monday i tried a 4 fuel rod 3 control rod laulut but it ended up being shorted from one side and longer from the other so the solution was to make some fuel rods 2 pixels wide and some 1 pixel wide and that looked stupid and also was horrible to control so thats the second reason i decided to have 5 fuel rods and 4 control rods instead
Migulel 24th August

this is my most liked creation now!!!

The Powder Toy

Mark II BWR/4 by Migulel

Comments