Comments

TNTPig1 14th May 2016

this is so hacked
Sandwichlizard 5th Apr 2016

pause the sim and click the reload button. then save it.
Sandwichlizard 5th Apr 2016

you cannot save it with the print head down. it assembles itself for a reason. particle order gets set when the save loads. it is critical for the correct print alignment.
Fatmeatball 3rd Apr 2016

When I save it to my local saves it just corrupts the print.
mdkbros 30th Mar 2016

WTF THAT IS SO COOL
Iforgot 17th Jan 2016

Woah...
Sandwichlizard 17th Jan 2016

there is a way to speed it up. but what your suggesting is not correct. it does not wait. It prints one 5x15 slab every 8 frames. sometimes that slab is empty so it apears to be doing nothing. that is where it can get faster. if I make the drive pstn's accept a binary call, then make a more sophisticated code system, It would only print a slab if there was something to print. it would only gain a few cycles on small opbects however.
oldmud0 17th Jan 2016

I think you can speed this up even further by syncing the print head with the filter with tighter timing. That way, the print head does not have to pause waiting.
Elite01 17th Jan 2016

i am thinking of making this print in parallel. meaning from top-to-middle and buttom-to-middle at the same time.
KungZacharias 17th Jan 2016

you just began a new era for tpt the 3D printers era (watch out for copiers cause you will get many of them i think)

The Powder Toy