The Powder Toy

Acid Resistance Tester by baky123

baky123
baky123
106 / 17
13th May 2014
17th May 2014
In TPT, all solids have a certain acid resistance. To test a solid, place it in the area indicated and unpause. Then wait for the acid to dissolve through the sponge and read off how far across it got. The higher the number, the better the resistance.
tester acid resistance gold ripinpasta ttanfail putanar qrtzwinsit glasswins qrtzwins

Comments

  • dyaomaster
    dyaomaster     9th Jan 2016
    woah. LN2 is unaffected by acid!
  • dyaomaster
    dyaomaster     9th Jan 2016
    Someone's 1-pixel bomb: 13 (I take no credit)
  • dyaomaster
    dyaomaster     9th Jan 2016
    GBMB: 1.4 (I replaced bottom line with DMND for test)
  • dyaomaster
    dyaomaster     9th Jan 2016
    Salt: 9.4 Gel: 1.3 ANAR: 0.3 none: 0.2 PLSM: 13
  • jasiu2002
    jasiu2002     8th Dec 2015
    This could use some improvements. The difficulty increases further on the scale, since a lot of acid is eating through the start and digs into it so there's only a little bit at the end. To start off this would need clone, but even with clone it doesn't work THAT good.
  • penguindude
    penguindude     21st Nov 2015
    TUNG has slightly higher resistance than FILT.
  • JediJakob
    JediJakob     18th Nov 2015
    @catsaretheworst u are so retarded ur not supposed to blow it up
  • LegenDUST
    LegenDUST     1st Nov 2015
    CRMC 3.6
  • Nickname
    Nickname     5th Jun 2015
    Smoke got 13?
  • Nickname
    Nickname     5th Jun 2015
    acid got 13