The Powder Toy

annoying water prob.

  • garretemo     6th Apr 2011 Member 0 Permalink
    Why is it when I'm trying to make a water timer (with wall or most anything else) water paticles disapear, or somtimes replace other elements?
  • Racer-Delux     6th Apr 2011 Member 0 Permalink
    Is heat simulation on? If so, there is your problem. Also, do not use INSL to hold water.
  • cctvdude99     6th Apr 2011 Member 0 Permalink
    @Racer-Delux
    Why not?
    @garretemo
    Yes, I've had that once before. But only once.
  • garretemo     6th Apr 2011 Member 0 Permalink
    @Racer-Delux
    OK, but will other people that view my stuff have the problem unless the change theirs too?
  • cctvdude99     6th Apr 2011 Member 0 Permalink
    @garretemo
    No, heat display is a view mode, heat simulation is next to the new simulation button.
  • Racer-Delux     6th Apr 2011 Member 0 Permalink
    Heat simulation can cause water to evaporate when sparked.

    When you turn heat sim off in your save, then save it with the heat sim off, other people will load the save without heat simulation.

    Load the electronics I make, you will see heat sim is off.
  • garretemo     6th Apr 2011 Member 0 Permalink
    sorry I edited.




    @Racer-Delux
    Ahhh, I see. Thankyou. I'm done
You need to login before you can post replies