Deco Problem

  • thechubbyhusky
    August 2017 Member 0 Permalink

    So I've been having this problem recently where when I'm using deco and I sample a colour, then go into the colour editor to change it or something, it always goes to a random colour. e.g *samples blue *enters colour editor. Then instead of being on blue, it will be on some random shade of red or grey or something.

  • jacob1
    August 2017 Developer 0 Permalink
    Someone else reported this and I couldn't reproduce it. But I kept trying, and I just got it to happen

    image

    It affects Windows but not Linux, which is probably why I didn't notice it before. Reproduced here with CLST with .tmp <= 2
    Edited once by jacob1. Last: August 2017
  • docRoboRobert
    August 2017 Member 0 Permalink

    I had this problem yesterday. I had green colour set but the pointer was on light-red part.

  • Tasha04
    August 2017 Member 0 Permalink

    i had the same thing that happend to docroborobert

  • SpitFire32
    August 2017 Member 0 Permalink

    Same o/

  • thechubbyhusky
    August 2017 Member 0 Permalink

    So is there any way to fix this?

  • docRoboRobert
    August 2017 Member 0 Permalink

    I haven't had this problem since 12th August, so this isn't a big problem for me. I usually close TPT and run it again.

  • jacob1
    August 2017 Developer 0 Permalink
    @thechubbyhusky (View Post)
    I haven't fixed it yet. Once I do, you can use the snapshots
  • thechubbyhusky
    August 2017 Member 0 Permalink

    Ok cool thanks.

  • jacob1
    September 2017 Developer 0 Permalink
    This is now fixed in 92.2

    I didn't do anything to fix it, it just fixed itself. 92.1 was compiled incorrectly so that is probably what caused this.