Difference between revisions of "Element:DTEC"
m (BRAY ctype transfer) |
|||
| Line 41: | Line 41: | ||
You can set the tmp2 to determine the detection radius (in the shape of a square) | You can set the tmp2 to determine the detection radius (in the shape of a square) | ||
| + | |||
| + | DTEC can also detect the ctype of a BRAY in its tmp2 range and transfer it to a neighbouring FILT. This is useful for FILT ctype based electronics. | ||
{{Languages}} | {{Languages}} | ||
Revision as of 00:10, 4 January 2017
| Properties | |
|---|---|
| Section | Sensors |
| Spawn temperature | 22°C |
| Heat Conductivity | 0% |
| Relative weight | 100 |
| Gravity | 0 |
| Acid dissolve rate | 0.1% |
| Flammability | 0 |
| State | Solid |
| Source code | |
Detector generates a SPRK when its ctype element is nearby. To set its ctype, draw over it with an element like you would with CLNE. Make sure you don't accidentally set its ctype when drawing the wires around it. DTEC is a replacement for detector wall so that you can make your creations smaller.
You can set the tmp2 to determine the detection radius (in the shape of a square)
DTEC can also detect the ctype of a BRAY in its tmp2 range and transfer it to a neighbouring FILT. This is useful for FILT ctype based electronics.
| Language: | [[::Element:DTEC|English]] |
|---|
